Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

8330A never going into Standby

sbright, modified 5 Years ago.

8330A never going into Standby

Youngling Posts: 1 Join Date: 2/11/17 Recent Posts
Hi,

I can't get my speakers to go into standby mode. I am using the GLM software (ver 2.1.0) and have set the sleep timer to 10 minutes and stored the setting to the monitors. The monitors are connected using the digital in from a SOtM USB Audio 2 from my PC.

Thanks
manutal, modified 5 Years ago.

Re: 8330A never going into Standby

Jedi Knight Posts: 180 Join Date: 4/25/14 Recent Posts
The monitors should go to sleep then (in 10mins) after the signal from the source(your usb interface or soundcard) has been shut down. There are no dip switches on the 8330A so the only thing that it could be are that you still have your usb interface powered up or the PC still on. After you close the GLM software + the signal source the ISS should turn on after chosen time, if not then its out of my league. I guess the signal should also disappear if you choose some other playback device from your computer(headphones etc) via the computers own soundcard.
ilkka-rissanen, modified 5 Years ago.

Re: 8330A never going into Standby

Yoda Posts: 2564 Join Date: 3/23/09 Recent Posts
Hi,

Can you please check if ISS works if you unplug the signal cables? If it does, it tells you that the computer is sending out digital signal (silence) all the time which prevents the monitors from entering the ISS state.