Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

8010AP + 7050C

mrkva, muokattu 4 Vuodet sitten.

8010AP + 7050C

Youngling Viestejä: 0 Liittymispäivä: 14.2.2019 Viimeisimmät viestit

Hello everyone,

I am looking for your suggestions regarding setting up the input sensitivity of 7050C in combination with 8010AP for "flat" sound.

Thank you,

Jonas Gruska

costakis, muokattu 4 Vuodet sitten.

RE: 8010AP + 7050C

Padawan Viestejä: 76 Liittymispäivä: 13.2.2019 Viimeisimmät viestit

Start with the suggestions from Genelec. Then measure and fine-tune. You can use REW with a compatible microphone. A prediction from me is that you have to start with the sensitivity knob of the 7050 in the lowest level. 

The result is depending greatly by the acoustic properties of the room.

Costakis