Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support


8351 & 7380A Calibration with Turntables

icedriller, muokattu 3 Vuodet sitten.

8351 & 7380A Calibration with Turntables

Youngling Viestejä: 1 Liittymispäivä: 4.9.2017 Viimeisimmät viestit


I recently purchased a pair of 8351's and a 7380 Sub for monitoring for my DJ setup and for the home stereo.

When using the Auto Calibration, I am finding it is leaving a large bass hole in my sound.

I have tried correcting this in the Room Response Controls, but it just seems to keep sounding thin. I have a tight notch at 39.7Hz for a turntable feedback or room node, but I can't seem to get the low end back.

Does anyone have any suggestions or experience with setting this type of monitoring system up with turntables. All feedback appreciated.




lukester, muokattu 3 Vuodet sitten.

RE: 8351 & 7380A Calibration with Turntables

Jedi Master Viestejä: 296 Liittymispäivä: 22.4.2010 Viimeisimmät viestit

the notch you're seeing can't be related to turntable feedback.

Auto calibration happens only inside the speaker system, regardless of source.

You can absolutely disable the room corrections one-by-one or as a whole.

It's not unusual to experience auto calibration as thin or a bit over-optimised in home setups.


And again, the source being turntables doesn't figure into the equation.
Or at least i sincerely hope that you're not playing at volumes where feedback would become a problem ;)



also Luke