Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Best way to go about my setup?

ay, muokattu 3 Vuodet sitten.

Best way to go about my setup?

Youngling Viestejä: 6 Liittymispäivä: 24.3.2019 Viimeisimmät viestit

Hello

My setup is going to be PC->Focusrite 2i2 interface->8330 Speakers analogue input mode

How do I maintain the best dynamic range of the signal chain?

I have been told that the digital volume control in Windows works by changing the bit numbers so I have it set at 100% but I am not sure how Genelec does it with the GLM software

Should I leave the interface volume knob at 50%(for example) and control the volume using GLM, or should have leave the GLM at 100% as well and use the analogue volume knob?

Hope that makes sense

Thanks

manutal, muokattu 3 Vuodet sitten.

RE: Best way to go about my setup? (Vastaus)

Jedi Knight Viestejä: 180 Liittymispäivä: 25.4.2014 Viimeisimmät viestit
Windows full volume. Use the knob/GLM for volume control