Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Sub 7050b direct connection ??

powerestudio, muokattu 3 Vuodet sitten.

Sub 7050b direct connection ??

Youngling Viestejä: 3 Liittymispäivä: 7.4.2019 Viimeisimmät viestit

Hello,

I am going to install a 7050b in my set up: Is it possible using an output signal for the sub or is it a must pass through the signal from sub to monitors.

Well my idea is using the sub for a 2 set of monitors (only a pair is from Genelec ) 

Crane Song Avocet  controller---->out1 to monitors (you choose A or B)

                                              ---->out2 to 7050b

 

Thank you

costakis, muokattu 3 Vuodet sitten.

RE: Sub 7050b direct connection ??

Padawan Viestejä: 76 Liittymispäivä: 13.2.2019 Viimeisimmät viestit
Yes, you can. You can connect the Genelecs through the in-out connections and follow proper settings. You can use any other input of the sub to feed it with the other set of speakers, please note that the proper settings of the sub for the Genelecs, will be the same.