Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Can I DIY one usb cable for GLM adapter to separate the signal and power?

meng, muokattu 2 Vuodet sitten.

Can I DIY one usb cable for GLM adapter to separate the signal and power?

Padawan Viestejä: 27 Liittymispäivä: 17.12.2015 Viimeisimmät viestit

If it's works, I don't need to change the USB cable when I shut down the computer, right? 

Any suggestions or guidance?

It's the standard usb interface definition, right?

jani-oksanen, muokattu 2 Vuodet sitten.

RE: Can I DIY one usb cable for GLM adapter to separate the signal and powe

Jedi Master Viestejä: 449 Liittymispäivä: 30.3.2017 Viimeisimmät viestit

Hi There,

I asked from R&D, and their reply: The computer might send “suspend” state any way and the adapter goes off. I have try to use a powered USB HUB and the adapter went OFF.


Best Regards,
Jani Oksanen
Customer Support Team