Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

How do I get both L + R ch's to 8020A's connected in series

arteta2k, muokattu 3 Vuodet sitten.

How do I get both L + R ch's to 8020A's connected in series

Youngling Viestejä: 0 Liittymispäivä: 3.5.2020 Viimeisimmät viestit

I seem to be having difficulty in getting both 8020A monitors to matching volumes. My Tascam DA3000 naturally has 2x XLR outputs (left and right). If I am to daisy chain two 8020A's, I would not be able to connect the Tascam to the monitor already receiving an XLR from the first 8020A. Do I need a Y-cable? If so, has anyone got the spec.?