Source management of 8341 monitor

Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

HarriStockholm, muokattu 3 Vuodet sitten.

Source management of 8341 monitor

Youngling Viestejä: 3 Liittymispäivä: 28.5.2020 Viimeisimmät viestit

I¨'m about to install my loudspeakers to my hifi system and have following queries:

1. For the analog input, does the signal go through a A/D before the crossfilter and the room correction?

2. Can I use the GLM volym control for analog input. I don't get any sounds from the loudspeakers while the GLM i connected to the computer. I only get the sound to work when I disconnect from the PC. The speakers filter is switch to "store". I'm using the roomcorrection in GLM.

3. Is there any advantages to connect my CD player direct with AES connector to the loudspeaker compare to through my Mytek DAC+ preamp regarding hifi quality. I'm thinking to connect all my sources through AES Switch and use the GLM volym control. Does that work? That would be a very "clean" system.