Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Modifying subwoofer low-pass

jemand, muokattu 3 Vuodet sitten.

Modifying subwoofer low-pass

Youngling Viestejä: 0 Liittymispäivä: 3.7.2020 Viimeisimmät viestit

Hello, I have a pair of 8040 speakers, and I like them very much. Even the bass is very good, to some 45 Hz.

I use these solely for listening to music, and do not need earthquaking volumes.

Mainly for organ music, I would like to add a subwoofer. The lowest notes of a big organ go down to some 16 Hz. With a 7060 or 7360 this could almost be reached but I think the 85 Hz crossover frequency is a bit high. I think the basses would sound nicer when reproduced by the 8040:s, with a better soundstage, too. The sub would essentially just handle the lowest octave.

I have understood that the 7000-series crossover cannot be set to lower than 85. 

Is there a way to get around this?

Or, am I getting this hole thing wrong? ; )