Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

GLM4 Beta 0.4.10 - Subwoofer Phase Calibration not working

sfmedia, muokattu 3 Vuodet sitten.

GLM4 Beta 0.4.10 - Subwoofer Phase Calibration not working

Youngling Viestejä: 3 Liittymispäivä: 20.11.2020 Viimeisimmät viestit

Update: It seems I missed the new "profiles" section and accidentally set the profile to "stereo" instead of 2.1 - creating a new calibration allowed me to run the subwoofer auto phase calibration step properly. It is odd, however, that in "stereo" mode it runs a silent "subwoofer calibration" without any feedback that this is not going to have an effect. So perhaps a quirk to work out.

2x 8330, 1x 7350

Running digital mode.

The 0.4.10 update forced me to recalibrate on launch and the subwoofer phase part of the calibration process ran, but was silent. Previously I could hear the subwoofer increasing and then decreasing in volume during that portion of the calibration (with GLM3 in a previous room).

Mac OS 10.15.7

volkerk, muokattu 2 Vuodet sitten.

RE: GLM4 Beta 0.4.10 - Subwoofer Phase Calibration not working

Youngling Viestejä: 2 Liittymispäivä: 30.12.2019 Viimeisimmät viestit

Hi, I experience the same issue both with the modes "Stereo" and "2.1". Calibration works, Autophasingc SW-wise seems to act but with no sound (in previous versions it was possible to hear the phasing activity) - so finally it does not work... Ending the phasing with a microsecond bass pump sound - sounds not healthy. Running analogue, 2x 8341AW, 1x7360APM. It seems to be a bug in the 0.4.10 version, on the previous auto phasing worked. BR. Volker