Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Is 40 Watts Enough For Fluance Bipolar Surrounds?

rohit, muokattu 8 Kuukautta sitten.

Is 40 Watts Enough For Fluance Bipolar Surrounds?

Youngling Viestejä: 1 Liittymispäivä: 26.1.2021 Viimeisimmät viestit

Thinking about getting the Amphony wireless speaker 1700 kit and an additional amp/receiver. Each amp/receiver is rated at 2x40watts (I think that means it can only put out 40 watts per speaker). One each will drive a Fluance Signature Hi-Fi Bipolar Surround Sound Speaker. I'm using these speakers as side surrounds in a 5.1 setup, in a fairly large room.

Is that wattage enough?

The Fluance specs say power handling is 30 - 120 Watts RMS, so I think I'm good. I would get the Amphony 1800 kit which has 2x80watt amps but those are back ordered until March.

Thanks

https://sarkarijobs.gen.in/

 

lukester, muokattu 11 Kuukautta sitten.

RE: Is 40 Watts Enough For Fluance Bipolar Surrounds?

Jedi Master Viestejä: 296 Liittymispäivä: 22.4.2010 Viimeisimmät viestit

This is a forum for specialized speakers from finland that last a lifetime.

this is our speaker to room volume chart:
https://www.genelec.com/correct-monitors

you can look up the wattage of the speakers to reverse-engineer that.