Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

2x Stereo with L Shaped Room - is that possible with 3 Speakers? + Sub?

sternenlicht, muokattu 2 Vuodet sitten.

2x Stereo with L Shaped Room - is that possible with 3 Speakers? + Sub?

Youngling Viestejä: 0 Liittymispäivä: 29.2.2020 Viimeisimmät viestit

2x Stereo with L Shaped Room - is that possible with 3 Speakers? 

I have a recording corner, where i record my drum machines and synthesizers, and a desk where my DAW production runs.  

Currently i have setup 2x 8330 on the recording corner, but i would like to add another 8330 on the other side of the room, so i could repurpose the corner speaker, when i do mixing in the DAW. 

It would look like this: 4x Analog In to the 7350 -  but only 3x Output from the 7350. 

Are the analog input of the 7350 hard wired?  - i.e. input 1 to output 1 , input 2 to output 2.  

I have a switching matrix dsp, i could possibly use that to route the signals, but i would like to avoid that, because its an additional device, which i need then to reconfigure each time, i switch setup - not integrated in the SAM system. 

So what i need to understand, is if i could route analog signals in the 7350 ? Or is that hard wired?

kind regards

Marcus  (sorry - its a maybe unusual setup.)