Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

GLM + 7370A + 8350A + 8351B for full range L/C/R?

fomo, muokattu 1 Vuosi sitten.

GLM + 7370A + 8350A + 8351B for full range L/C/R?

Youngling Viestejä: 7 Liittymispäivä: 1.3.2021 Viimeisimmät viestit

When using SAM speakers for home theater, if I have 2x 8350A as my main Left/Right and one 8351B as my Center channel, all 3 can be connected to a single 7370A subwoofer and with GLM can be treated as "full range" speakers correct? So then I can tell my processor to send the L/C/R signal with no low frequency cut-off to the 7370A because GLM would have already determined all the necessary crossover points between the 7370A and 8350A. Just making sure this is feasible.

costakis, muokattu 1 Vuosi sitten.

RE: GLM + 7370A + 8350A + 8351B for full range L/C/R?

Padawan Viestejä: 76 Liittymispäivä: 13.2.2019 Viimeisimmät viestit

So, the question is: select the speakers as "Large" (with the subwoofer connected to the satelites) or "Small" (with subwoffer connected to the sub-out of the AV processor) ? You can try both. In the first case the cross-over will be determined from the speakers and in the second from the AV processor. In the second case, I don't know if GLM allows additional setting of the fcut-off requency.    

fomo, muokattu 1 Vuosi sitten.

RE: GLM + 7370A + 8350A + 8351B for full range L/C/R?

Youngling Viestejä: 7 Liittymispäivä: 1.3.2021 Viimeisimmät viestit

Exactly. I'm thinking letting the GLM decide where the cross-over is because isn't that the core value of GLM as it knows my drivers better than any AVR!

lds, muokattu 1 Vuosi sitten.

RE: GLM + 7370A + 8350A + 8351B for full range L/C/R?

Youngling Viestejä: 2 Liittymispäivä: 3.11.2019 Viimeisimmät viestit

You would do both, ideally. Pass the L/C/R channels through the 7370A so that you get an extended frequency response, but also attach your sub channel to the LFE input on the 7370A so that it gets used for any low frequency effects. 

fomo, muokattu 1 Vuosi sitten.

RE: GLM + 7370A + 8350A + 8351B for full range L/C/R?

Youngling Viestejä: 7 Liittymispäivä: 1.3.2021 Viimeisimmät viestit

thanks!