Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Setting up 8020b's with 7050b - Input Sensitivity Setting

mrsdoubtfire, muokattu 1 Vuosi sitten.

Setting up 8020b's with 7050b - Input Sensitivity Setting

Youngling Viestejä: 3 Liittymispäivä: 7.5.2012 Viimeisimmät viestit

Hello, I am setting up a pair of 8020bs with a 7050b. I have the 2nd dip switch enabled on both of the 8020bs to enable the 85 Hz cross over but I need some advice on the input sensitivity setting for the 7050b.

 

Question 1 - On the 7050b, which side of the input sensitivity knob is the one I should use for calibration to the numbers, the flat side or the curved side?

Question 2 - which is a good 'starter' setting for the input sensitivity?

 

Thanks!

costakis, muokattu 1 Vuosi sitten.

RE: Setting up 8020b's with 7050b - Input Sensitivity Setting

Padawan Viestejä: 76 Liittymispäivä: 13.2.2019 Viimeisimmät viestit

Its better to read the manual :) It's really simple, you only need a db meter (or a measurement microphone).