Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Ethernet cable upgrade for GLM 3 adapter (GLM 4.1 software)

manjigo, muokattu 9 Kuukautta sitten.

Ethernet cable upgrade for GLM 3 adapter (GLM 4.1 software)

Youngling Viestejä: 5 Liittymispäivä: 15.12.2020 Viimeisimmät viestit

Hi!

 

I am currently setting up a new studio in a old house, I have new ground wires and earth fault circuit breakers.

I am re-cabling everything to balanced and/or shielded cables to eliminate as much noise as possible/ reduce digital jitter/ maintain steady audio quality. I also have power conditioning, not the cheap type.

 

My question is, should I change the ethernet cabling from my GLM adapter to the monitors and upgrade them from the Cat5E UTP that comes with the GLM kit?

 

 

which ethernet cable type is the best for best possible signal and noise reduction for the GLM kit?

 

Cat7 STP

Cat7e STP?

 

or is it just stupid to shield the ethernet cable?

 

 

 

 

 

 

 

lukester, muokattu 9 Kuukautta sitten.

RE: Ethernet cable upgrade for GLM 3 adapter (GLM 4.1 software)

Jedi Master Viestejä: 296 Liittymispäivä: 22.4.2010 Viimeisimmät viestit

Nahw, there's no reason to upgrade the ethernet cables.
Ethernet only carries our control data, no audio.

Shielded ethernet cables are a good idea per se, but any shield is only as good as the ground on the router.
And If you check you router, you'll find it isn't grounded. (unless it's a cisco for 2 grand)