Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

legacy monitor 8250A + current subwoofer 7360A matching

jappi, muokattu 5 Vuodet sitten.

legacy monitor 8250A + current subwoofer 7360A matching

Padawan Viestejä: 36 Liittymispäivä: 28.7.2016 Viimeisimmät viestit
Do 73xx subwoofers have full functionality with older 8250A dsp-loudpeakers?

Would 7360A be match for the speakers in terms of output capability?

If GLM-system is used what is the recommended LP-HP frequency for the setup?

If individual correction is used the other monitor has relatively fine response, but other has sharp nulls at 110 and 150 Hz could it/how should this be compensated with single 7360A subwoofer? Room placement is not symmetrical. Other monitor has roughly 1 m distance to side wall and the other 2,5 m. Subwoofer can be placed freely between the monitors.

Thanks for the replies!
markus-kahelin, muokattu 5 Vuodet sitten.

Re: legacy monitor 8250A + current subwoofer 7360A matching

Jedi Knight Viestejä: 109 Liittymispäivä: 16.3.2010 Viimeisimmät viestit
Hi!

Yes, 7300-series subwoofers have full functionality with 8240A and 8250A, requiring that the monitors have the latest firmware installed. The firmware is supplied with the latest GLM 2.2 version, with integrated installer in the software.

7360A is not a good match with 8250A in terms of performance, the subwoofer can't play equally loud. Better match would be one step bigger 7370A.

Room related cancellations over 100Hz can not be compensated easily with the subwoofer, since the available frequency for the bass management filtering is maximum 100Hz. Best option is to try positioning the speakers in different configuration, trying to maintain as symmetrical placement as possible.
jappi, muokattu 5 Vuodet sitten.

RE: Re: legacy monitor 8250A + current subwoofer 7360A matching

Padawan Viestejä: 36 Liittymispäivä: 28.7.2016 Viimeisimmät viestit

Hi Markus,

how about using two 7360A subs in the front corners below 100 Hz and using the filters in the monitors to correct mid bass region? With two units the output would definitely match 8250A plus the the acoustic response would likely flatten even before using any filter correction.

More symmetrical positioning for monitors unfortunately is a bit tricky subject. I might need to file in an application if you know what I mean... ;)