Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

1038a and 1038ac different

stefan75, muokattu 5 Vuodet sitten.

1038a and 1038ac different

Youngling Viestejä: 16 Liittymispäivä: 18.3.2017 Viimeisimmät viestit
Hi, should a 1038a and a 1038ac sound the same?

When I send the same signal to each speaker LCR, the 1038ac sounds quite different. It's much brighter than the two 1038.

I've played with the dip switches and moved the speakers away from the wall. But the main difference I hear there is more or less bass.

What could the reason be?
markus-kahelin, muokattu 5 Vuodet sitten.

Re: 1038a and 1038ac different

Jedi Knight Viestejä: 109 Liittymispäivä: 16.3.2010 Viimeisimmät viestit
Hi!

These modes should indeed sound very similar. Have you checked that your preamp/processor has the same settings for all from channels and no Eq applied? You would need to get frequency response measurements done to analyze the performance better. One easy and affordable option is to use this software, with a computer sound card and a measurement microphone: https://www.roomeqwizard.com/