Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Three 8020B's broke down when turned on

maheinon, muokattu 5 Vuodet sitten.

Three 8020B's broke down when turned on

Youngling Viestejä: 2 Liittymispäivä: 8.4.2010 Viimeisimmät viestit
I have 5.1 home theater system with Genelec 8020Bs and 7050 BPM.

I turned 3 monitors and sub on from one switch, some weird noise came out of them so I turned them down. But when I tried to turn them on again, they didn't, no green light, no sound.
2 back monitors are still fine since they were wired but not switched on.

I'm electrical engineer so I took liberty to open the small plate from 8020B's back. The fuse seemed to be fine.

What could be the issue with those monitors and sub? Something broke some component but not the fuse?
ilkka-rissanen, muokattu 5 Vuodet sitten.

Re: Three 8020B's broke down when turned on

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

I would advice you to fill out an official service enquiry form: http://www.genelec.com/customer-service