Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Converting 9000A to 9310A pot.

kevs, muokattu 5 Vuodet sitten.

Converting 9000A to 9310A pot.

Youngling Viestejä: 12 Liittymispäivä: 26.7.2014 Viimeisimmät viestit
I have 2 extra 9000A vol controllers & need a 9310A vol controller for my sub/sat setup. I have rewired the internal plugs on a 9000A to make the proper ckt. to the 3.5mm plug, but need to replace the pot to get the same taper as the 9310A. Where can I source the pot that is in the 9310A volume controller? Can I order from Genelec or is this pot available from parts suppliers? If it's commercially available, can I get the specs?
BTW My knobs are not glued to the pots. Maybe an older model that came with the 5040A
Thanks,
kev
ilkka-rissanen, muokattu 5 Vuodet sitten.

Re: Converting 9000A to 9310A pot.

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

Unfortunately I can't provide more detailed information nor can recommend this kind of "hack". I recommend that you purchase the original 9310A volume controlled instead.