Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

1029A dismantle for painting

mdenton127, muokattu 7 Vuodet sitten.

1029A dismantle for painting

Youngling Viestejä: 1 Liittymispäivä: 10.4.2016 Viimeisimmät viestit
Hi !! I have inherited a couple of 1029a, which work perfectly but they have been scuffed up rather badly (slid around on surfaces I think) so I am wondering whether is is OK to dismantle them, at least partially, so I can repaint them. Anyone got any advice on this ? Are there any seals that might need replacing ? Any advice appreciated.
ilkka-rissanen, muokattu 7 Vuodet sitten.

Re: 1029A dismantle for painting

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

We do not recommend disassembling any of our products because you might need special tools, knowledge and typically replace seals to prevent the cabinets from leaking. You should contact your local distributor and their service center instead.