Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

intermittent hum on 8030a

mikejonesfvu, muokattu 7 Vuodet sitten.

intermittent hum on 8030a

Youngling Viestejä: 2 Liittymispäivä: 20.12.2012 Viimeisimmät viestit
8030a currently installed in an art gallery installation set up. Has been performing perfectly fine for a couple of weeks. Intermittent fault seems to have crept in. All fine on power up, but then after around 4 hours suddenly getting loud buzzing noise - a little like half pulling a jack out of mixer - cycling the power on the speaker seems to clear this, but not consistent in the time before fail. Doing all the usual checks on other parts of the rig - cable swaps etc. Anyone come across this? Thanks
ilkka-rissanen, muokattu 7 Vuodet sitten.

Re: intermittent hum on 8030a

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

It does sound like some sort of strange problem inside the speakers electronics. I would advice you to contact your local distributor and request a service.

http://www.genelec.com/where-buy
mikejonesfvu, muokattu 7 Vuodet sitten.

Re: intermittent hum on 8030a

Youngling Viestejä: 2 Liittymispäivä: 20.12.2012 Viimeisimmät viestit
Thanks Ilkka. I'll try this. The problem appears to go away when volume on speaker is lowered - though the level was not excessive, and the same as 3 other identical model speakers in the installation set-up. Will contact for service advice.