Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

8020CPM grille that protects the tweeter

rifat, muokattu 8 Vuodet sitten.

8020CPM grille that protects the tweeter

Youngling Viestejä: 2 Liittymispäivä: 3.6.2015 Viimeisimmät viestit
I bought new 8020 CPM. On one 8020 grille that protects the tweeter installed a little crooked. On the grid in a circle, there are traces of glue. Is it a manufacturing defect or as it should be?
ilkka-rissanen, muokattu 8 Vuodet sitten.

Re: 8020CPM grille that protects the tweeter

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

The grille is attached with glue so I am suspecting it's all normal, but can you post a picture of it for me to see it?
rifat, muokattu 8 Vuodet sitten.

Re: 8020CPM grille that protects the tweeter

Youngling Viestejä: 2 Liittymispäivä: 3.6.2015 Viimeisimmät viestit
Hi,

can you post a picture of it for me to see it?


Hi,
http://s019.radikal.ru/i621/1506/95/ee7ffe571dd6.jpg
ilkka-rissanen, muokattu 8 Vuodet sitten.

Re: 8020CPM grille that protects the tweeter

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Thanks! There seems to be an issue with the grille placement, it seems to be misplaced so that the lower right (on the picture) edge has been popped out of the small groove where it should sit nicely. I would contact your local distributor for more information: http://www.genelec.com/shop/distributors-network/