Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Genelec 1091A home theater, new member

jack52, muokattu 8 Vuodet sitten.

Genelec 1091A home theater, new member

Youngling Viestejä: 1 Liittymispäivä: 28.12.2014 Viimeisimmät viestit
Hello, I'm new on this forum so please excuse me if I post this at the wrong place.

I own a Bang and Olufsen surround sound setup and a beovision tv. The tv has a surround sound processor build in so all the (active) loudspeakers are connected to the beovision. Last week I was given a Genelec 1091A subwoofer. A custom made cable came with it (Powerlink to XLR) to connect the subwoofer to the subwoofer output, unfortunately only very little sound (low volume) is produced. Am I doing something wrong or is it impossible to use a the sub in combination with Bang and Olufsen?


Thank you for your help.

Jack
ilkka-rissanen, muokattu 8 Vuodet sitten.

Re: Genelec 1091A home theater, new member

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

It is not recommended to use the subwoofer in that system. The end-result will be unknown. Our subwoofers are meant to be used with suitable Genelec speakers only, please see more information here: http://www.genelec.com/products/previous-models/

It seems that the signal level is too low for the subwoofer and therefore you will get only little sound. Can you adjust the subwoofer output level at all from the B&O processor?