Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Room Measurements and Dip Switches

poleepkwa, muokattu 7 Vuodet sitten.

Room Measurements and Dip Switches

Youngling Viestejä: 6 Liittymispäivä: 5.12.2012 Viimeisimmät viestit
Hello Ilkka!

I was one of the lucky ones this year and the Genelec boys stopped by during the Genelec Kalibrointikiertue 2014
and measured my little home theatre. After an informative discussion I decided to move the speakers (8040a') around and see if I could improve on the big dip I had between 200-300 Hz. I lifted the center up so that all the speakers are now on the same height. All speakers are wallmounted so it took a while. After much experimenting and measuring this was the best I could do.

Now my real question is: Genelec recommended during the calibration that not to use the Bass tilt as it further increased to dip in the bass response. I have now moved the speakers up and the dip is a bit smaller than it used to be. Looking at the measurements of my speakers, which one of the settings are more neutral and why? I am needing some guidance as to what I should be looking at to get a more neutral response. For stereo I use the Fronts without any calibration. Audyssey XT32 does a pretty good job integrating the subwoofer and mains, it however boosts the dips so don't know if that's a good thing or not. Thank you for your time and assistance.
poleepkwa, muokattu 7 Vuodet sitten.

Re: Room Measurements and Dip Switches

Youngling Viestejä: 6 Liittymispäivä: 5.12.2012 Viimeisimmät viestit
More measurements:
poleepkwa, muokattu 7 Vuodet sitten.

Re: Room Measurements and Dip Switches

Youngling Viestejä: 6 Liittymispäivä: 5.12.2012 Viimeisimmät viestit
Anyone have any opinions to share?