Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

New DSP 2.1 Setup In Mono? - Dip switch?

mackcovski, muokattu 9 Vuodet sitten.

New DSP 2.1 Setup In Mono? - Dip switch?

Youngling Viestejä: 4 Liittymispäivä: 11.10.2013 Viimeisimmät viestit
Hi everyone,
Hoping for a quick fix here. I just set up my new 2.1 monitors 7260A and 2 x 8240A and it appears I am getting
mono only. (as i can pan a signal from the desk hard left an hard righ and get no change in the volume of either monitor) The cabling is good, GLM runs fine - finding all monitors, Autocal runs fine and appears to be doing its job.

The setup wizard runs fine and I select the appropriate cabling preset -I am sure it comes down to the dip switch settings on the back of the monitors. On page 24 (and further) of the manual it talks about subframe A and B. I get that and I am using the correct AESEBU cables supplied by the retailer. To the Sub , out to the 8240 thru to the second 8240 But it doesn't say - or I cant find where it says whether GLM or I have to make the selection on the back of the monitors.

What Am I missing?

Thanks
digipete, muokattu 9 Vuodet sitten.

Re: New DSP 2.1 Setup In Mono? - Dip switch?

Padawan Viestejä: 99 Liittymispäivä: 18.6.2011 Viimeisimmät viestit
Are you sure your sound card is running single wire as it should and not dual wire.
Alternatively connect speakers individually with each their AES/EBU cable.
ilkka-rissanen, muokattu 5 Vuodet sitten.

Re: New DSP 2.1 Setup In Mono? - Dip switch?

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

It's not about dip switches because all controls are done through GLM. Only the first dip on second row should be on to save the settings to the speakers.

You should open acoustical settings editor in GLM and look for "Force input/Solo". Other speaker should read "Digital A" and the other "Digital B", referring to AES/EBU subframes. You can't change the setting there, though, you have to do it during GLM setup, cabling wizard.