Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

8020A with 5050A

aliboogie, muokattu 9 Vuodet sitten.

8020A with 5050A

Youngling Viestejä: 1 Liittymispäivä: 5.2.2013 Viimeisimmät viestit
What is best way to plug the 8020A with the 5050A Sub? The 8020A on the 5050A or the 5050A on the Outputs of 8020A? I use an X-Desk to control my monitoring volume. May I leave my 8020A fully opened? What about the sensitivity of 5050A and 8020A bass RollOff ? Thanks!
ilkka-rissanen, muokattu 9 Vuodet sitten.

Re: 8020A with 5050A

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

You can choose between either option. If you go first to the sub and from there to the speakers, do not engage the 85 Hz bass roll-off. If from the output of the speaker, do engage the roll-off.

You can leave the speaker gains fully open. Please see the 5050A operating manual for further information on setting the level and phase.

http://www.genelec-ht.com/documents/opmans/OM5050a.pdf