Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support


One against wall, one against corner (8040)

david-, muokattu 9 Vuodet sitten.

One against wall, one against corner (8040)

Youngling Viestejä: 6 Liittymispäivä: 25.8.2011 Viimeisimmät viestit
Sorry for all the questions recently but I've recently gotten my 8040's and they're lovely, I'm just a bit curious about set up. I checked the set-up guide I got with it that tells me to use -4dB bass tilt when they're against a wall and -4dB basstilt AND -4dB bass roll off in corners. should I have them set the same way (both with just tilt) or should one be with the bass roll-off as well?

Regards, David.

Also, I think they're a bit too low placed on my table, is it okay to heighten them a couple of centimeters using a book or something? ^^

Edit: I'm also quite confused about the distance to the wall. I'm placing them quite close and according to the set up guide I'm supposed to have 5cm from the hole at the back to the wall? Even when I place one in a corner? is it even possible to have 5cm to the wall if you place it in a corner? :shock:
ilkka-rissanen, muokattu 9 Vuodet sitten.

Re: One against wall, one against corner (8040)

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit

The idea of using the room eq switches is to adapt the speaker ot the room acoustics around it. So this means that if the room acoustics around the speaker pair are different, you should use different settings. But please remember that the given settings are just recommendations, they are not set in stone, so to speak. You should always test and listen with different settings to find out which ones are best for your system and room.

it is perfectly ok to place them higher, actually you MUST do it, should you seek for the best possible sound quality. For example see this document: ... 20A-8020B/

The 5 cm is a minimum distance due to the reflex ports, but of course it's OK to have more than 5 cm! :)