Lose Right Hand speaker after Storing Setup

Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

andy-johnson-laird, muokattu 12 Vuodet sitten.

Lose Right Hand speaker after Storing Setup

Youngling Viestejä: 13 Liittymispäivä: 21.12.2010 Viimeisimmät viestit

I have two 8240 and a 7260. I'm using GLM 1.4.0 under Snow Leopard 10.6.7.

I did an initial calibration some weeks ago when I first got the system. Everything worked fine. I stored the setup at the current master level.

However this morning, without me making any changes, the whole system's gain appeared to increase about 10 to 15dB -- I had not altered any setting nor stored a new setting. All speakers are set to used stored setting.

Now, when I start GLM and load the setup file, everything works correctly and I get both L and R speakers. However, when I store the setup in all speakers at current master level, the right hand speaker goes away entirely. The groups diagram shows both left and right speakers with a green "Ch" and they are not soloed nor are they muted.

Once the speaker has gone away, if I quit GLM and restart it, the right hand speaker comes back. Also if I power cycle the right hand speaker, it comes back.

Anyone got any idea what I might be doing wrong?

As an aside, I have noticed that, when I store setup at current master level, often the gain level from the speakers is closer to full master level -- I've tried this several times, being *very* careful to select "With Current Master Level." Something is behaving very nondeterministically in GLM.

I have tried restarting the machine (several times). I've even offered sacrifices, disemboweled a goat. I still lose the right hand speaker if I store the settings (and the goat was really pissed off).

Could the problem be with the GLM network interface?

Regards
Andy

Regards
Andy