Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Question about Interactive Response Editor

congsu, muokattu 11 Vuodet sitten.

Question about Interactive Response Editor

Youngling Viestejä: 12 Liittymispäivä: 21.12.2010 Viimeisimmät viestit
Hi,

I have just used AutoCal for the first time and was browsing through the different options in the manual settings.
Now in the window "Interactive Response Editor" there are two options for smoothing: "Genelec Accu Smooth" and "Third Octave Smoothing" - the latter is activated by default.
What are the differences between the two algorithms and in which case would you recommend which one?

Thanks in advance!
ilkka-rissanen, muokattu 11 Vuodet sitten.

Re: Question about Interactive Response Editor

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

Genelec AccuSmooth™ is a proprietary frequency response smoothing algorithm that provides a higher resolution (narrower smoothing bandwidth) at low frequencies compared with the standard 1/3 octave smoothing, and similar resolution at high frequencies. This is used by AutoCal to ensure accurate placement of equalizing notch filters at critical/problematic bass frequencies.

The smoothing selection in the Interactive Response Editor is for viewing purposes only, it doesn't affect the actual AutoCal algorithm. So you can choose the one you prefer to look at, usually 1/3 octave smoothing is used by most users.