Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

5.1, use receiver or subwoofer bass management

jonathan-s, muokattu 11 Vuodet sitten.

5.1, use receiver or subwoofer bass management

Youngling Viestejä: 22 Liittymispäivä: 2.5.2009 Viimeisimmät viestit
Hi,

I'm going install an 8020+7050 5.1 system at a friend's place, and i'm thinking about if i should use the bass management in the sub or in the receiver, ie connect the 8020's directly to the receiver and set them as "small" or whatever, then connect the sub to LFE.

Which way is the best to go?
ilkka-rissanen, muokattu 11 Vuodet sitten.

Re: 5.1, use receiver or subwoofer bass management

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi,

Naturally we recommend to use the bass management found in the subwoofer. That way you can be certain that the very important and critical crossover region is being handled correctly. You may be able to end up with similar result by using AV receivers bass manager but usually it will require much more work and possibly additional acoustical measurements.

Remember to enable #2 dip on the 8020s.