Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

8020 + 7050b setup options

sean65, muokattu 12 Vuodet sitten.

8020 + 7050b setup options

Youngling Viestejä: 5 Liittymispäivä: 26.3.2010 Viimeisimmät viestit
Hi There,

I've just ordered the 7050b Sub to connect to my 8020b's. I thought I understood the setup based on the Genelec setup guide however when buying the extra cables the sales assistant suggested a setup that's caused me some confusion.

He explained that I only need two extra XLR cables as I would connect from the audio interface, left and right, into the sub inputs and then the sub output's,left and right, into the 8020's.

My interface does have an LFE out but I was told not to use it because the sub will do a better job of the crossover.

Is this correct? I'd imagine for optimum result that I should just follow the Genelec recommendations.

Please advise.

Many thanks

Sean
ilkka-rissanen, muokattu 12 Vuodet sitten.

Re: 8020 + 7050b setup options

Yoda Viestejä: 2564 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hi Sean,

The sales assistant is correct, you will need two extra XLR cables to route the main left and right signals through the subwoofer. However, if you are playing a source material having an LFE channel, you should also connect an XLR cable from the source's subwoofer out to the LFE input of the subwoofer. In that case you should also enable the subwofoer in the source device's settings. Both left and right main channels/speakers should be configured as large.

Also remember to enable the DIP switch #2 on the 8020Bs (whether there's LFE or not).