Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

Adjusting 1030A & 1092A

habakko, muokattu 13 Vuodet sitten.

Adjusting 1030A & 1092A

Youngling Viestejä: 1 Liittymispäivä: 9.7.2009 Viimeisimmät viestit
Hi there,
i am using a pair 1030 together with a 1092 sub and i have problems andjusting the input sesitivity.
The 1030 are placed against the front wall and the 1092 is in the middle of them.

I tried so many configurations, but all my recordings have a "peak" somewhere around 32 - 40 hz!!!

My actual config is:
1030: input sensitivity: +4, Bass Tilt: -4
1092: input sensitivity: +4, Phase: 180

I tried to change phase and input sens, but i'm not sure how to match die 1030 and the 1092.

Can anyone help me please!!!

Thx
christophe-anet, muokattu 13 Vuodet sitten.

Re: Adjusting 1030A & 1092A

Jedi Knight Viestejä: 188 Liittymispäivä: 23.3.2009 Viimeisimmät viestit
Hello,

Thanks for your post and question. The first step, before calibrating your system, is to place all loudspeakers and subwoofer correctly in the room. With the limited information you provide about your room layout, it is difficult to provide further guidelines and detailed advices.

So, to start, I would suggest that you read and follow the explanations given in our Quick Setup Guides and Operating manuals about speaker placement and typical calibration settings.

You can find all such documents in the following pages:

1030A:
http://www.genelec.com/products/previous-models/1030a/

1092A:
http://www.genelec.com/products/previous-models/1092a/

Let us know how it went!
Best regards,