Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

1024b - 1024c differences modifications ??

supersurrexit, muokattu 13 Vuodet sitten.

1024b - 1024c differences modifications ??

Youngling Viestejä: 1 Liittymispäivä: 1.5.2009 Viimeisimmät viestit
I have a pair of 1024c like this: The amplification has the sign of a type of being a 1024b at the back and there's a strange "C" sticker glued to the sloggan of the Genelec 1024b's "B" to cover it. It looks factory made because it's made of the same material and with the same font-type as the original sloggan were made of. What kind is my Genelec then? :|

Other questions: What are the original brand and type loudspeakers for my monitorboxes? The bass is RCF, the middle has no signs at all, the highs are Sonus-Faber... Thank you very much for every posts!
ilpomartikainen, muokattu 13 Vuodet sitten.

Re: 1024b - 1024c differences modifications ??

Youngling Viestejä: 4 Liittymispäivä: 24.3.2009 Viimeisimmät viestit
The main difference between 1024B and C is in the midrange driver. The 1024B has a 80 mm soft dome, while 1024C has a 5" cone driver made by Genelec. This driver was developed in 1988 for the flagship 1035A and it is used in all models from 1037B up. It is a high sensitivity, very low distortion unit capable of very high spl. The tweeter was D28 made by Dynaudio. Amplifier mechanical chassis is the same and also circuit topology between "B" and "C" is similar, but crossover filter is naturally different due to different driver. Amplifier power of "C" is slightly higher as well.

GENELEC
Ilpo Martikainen
D.Sc (Tech.) h.c.
Chairman of the Board and founder of Genelec Oy