Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Keskusteluryhmät

A pair of 8030s with double 5040a

kimjohimp, muokattu 4 Vuodet sitten.

A pair of 8030s with double 5040a

Youngling Viestejä: 1 Liittymispäivä: 17.1.2018 Viimeisimmät viestit

Hi,

Is it possible to chain a pair of 8030s and two 5040a subs together? E.g. with line cables from pre-amp to sub1's in and from sub1's out to sub2's in and from sub2's out to 8030s...? Would it work or is sub1 in that scenario providing filtered (high-pass) signal to sub2 and sub2 would not produce any low freq (below 85 Hz) at all...?

markus-kahelin, muokattu 4 Vuodet sitten.

RE: A pair of 8030s with double 5040a

Jedi Knight Viestejä: 109 Liittymispäivä: 16.3.2010 Viimeisimmät viestit

Hi!

 

This would not work, for the reason you point out. The output of the subwoofer is high-pass filtered. You could run only Left signal to the 1st sub and out to the left speaker and then Right signal to the 2nd sub and out to the Right speaker.

 

Best Regards, Markus

Genelec Support Team