Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

1032 bass woofer issue

bram.van.bergen, modified 4 Years ago.

1032 bass woofer issue

Youngling Posts: 0 Join Date: 7/22/18 Recent Posts

Hello there,

 

I have old set of 1032's (serial 210 and 211) witch i love to death. I have never had any problems until recently. 

 

On one of the monitors the bass woofer stops sometime out of nowhere. Without apparent reason. When i play them very loud they sometime jump back and work again, other times i have to give the amp board a little bang. 

 

Does anyone recognize this problem? or have a solution. 

 

Best regards, Bram

 

jani-oksanen, modified 4 Years ago.

RE: 1032 bass woofer issue

Jedi Master Posts: 449 Join Date: 3/30/17 Recent Posts

Hi Bram,

Sorry for late reply. It sounds like there could be a dry joint or the cable connector would need some cleaning. It would be best to have the monitors be checked by our distributor and authorized service. You can find their contact information from link below:
 

https://www.genelec.com/where-buy

Best Regards,
Jani Oksanen
Customer Support Team