Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

What is the dimension and position of the 8330 bottom hole

meng, modified 4 Years ago.

What is the dimension and position of the 8330 bottom hole

Padawan Posts: 27 Join Date: 12/17/15 Recent Posts
Could you tell me what is the dimension and position of the bottom mounting hole of 8330? Could you send me the relevant engineering drawings?
jani-oksanen, modified 4 Years ago.

RE: What is the dimension and position of the 8330 bottom hole

Jedi Master Posts: 449 Join Date: 3/30/17 Recent Posts

Hello,

I asked R&D regarding more accurate drawings, but they are confidential, sorry about that.

The thread is 3/8” UNC, 10mm deep. The hole center line is 10mm regarding your question mark distance on your drawing.

I hope this clarifies enough, and let me know if it is still unclear.

Best Regards,
Jani Oksanen
Customer Support Team