Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

8341's EQ only CUT FREQ

tiagoabrahao, modified 4 Years ago.

8341's EQ only CUT FREQ

Youngling Posts: 14 Join Date: 5/15/19 Recent Posts

hello there

i'm running my GLM USB system fine, along with my 8341's. I just noticed that its EQ can only CUTS frequency... not BOOST any.

I think it's maybe due to the fact that it's pointless to boost anywhere to "FILL THE GAP" but i would like to have a word on that. 

Is there any another explanation about it?

thanks!

regards

lukester, modified 4 Years ago.

RE: 8341's EQ only CUT FREQ

Jedi Master Posts: 296 Join Date: 4/22/10 Recent Posts

Yes, that is the reason.

 

You can't fill a dip a in the room response with EQ.

Also the folks at Genelec are hesitant to boost because you'd loose headroom, Max SPL.

tiagoabrahao, modified 4 Years ago.

RE: 8341's EQ only CUT FREQ

Youngling Posts: 14 Join Date: 5/15/19 Recent Posts
That's a word.  thank you!