Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

Bypassing my sub is turning it on

gus, modified 3 Years ago.

Bypassing my sub is turning it on

Youngling Posts: 6 Join Date: 5/28/18 Recent Posts

In have the 7350a and two 7330. I have calibrated them with GLM. When the bypass is pressed red the sub comes on and when grey its off. I cannot solo the sub. GLM 3. 1.1 build 159. firmware up to date. 

jani-oksanen, modified 3 Years ago.

RE: Bypassing my sub is turning it on

Jedi Master Posts: 449 Join Date: 3/30/17 Recent Posts

Hi There,
There is two bypass switches, one to bypass the subwoofer, and one the room calibration.

When bypassing the subwoofer, the subwoofer does not play audio. If you would like to only play subwoofer frequencies, I would recommend to make new group with subwoofer only in the group.

If you need any further information on how to do this, I would recommend to check the GLM manual from link below:

If you need any further information, don't hesitate to contact us at and we are also glad to assist more

​​​​​​Best Regards,
Jani Oksanen
​​​​​​​Customer Support Team