Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

Storing parameters in 8320A & 8330A

Bonk-70, modified 2 Years ago.

Storing parameters in 8320A & 8330A

Youngling Posts: 2 Join Date: 7/23/20 Recent Posts

Hello,

Since there are no dip switches on the above speakers I wonder what is stored in case of a power cut?

I noted that at least led light nor volume control is stored.

glm parameters 83xx
radzmar, modified 2 Years ago.

RE: Storing parameters in 8320A & 8330A

Youngling Posts: 19 Join Date: 6/25/20 Recent Posts

The SAM-speakers require the GLM kit to be fully usable since the software controls most of their audio settings. Stored are a few parameters you can change through GLMs groups settings.

Attachments:

janne-koo, modified 2 Years ago.

RE: Storing parameters in 8320A & 8330A

Padawan Posts: 73 Join Date: 10/26/15 Recent Posts

Calibration data IS stored, so are all other important settings; Some just have their own UI when writing the settings - such as the LED state.

Bonk-70, modified 2 Years ago.

RE: Storing parameters in 8320A & 8330A

Youngling Posts: 2 Join Date: 7/23/20 Recent Posts

Ok, thank you. So computer is needed to be connected after each power cut and parameters rewritten .´(

janne-koo, modified 2 Years ago.

RE: Storing parameters in 8320A & 8330A

Padawan Posts: 73 Join Date: 10/26/15 Recent Posts

Sorry for the late reply, but that's just completely wrong. As I wrote before, all important settings - if not all settings - are stored in each individual component and the configuration survives lengthy periods without power.

​​​​​​​Volume control is done either via the source, GLM in standalone mode (power via USB, no computer attached) or via GLM software. Startup and maximum levels (and individual adjustments to component levels) is specified separately and stored.