Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

8030C Input Sensitivity with DJ Mixer

JankoV, modified 2 Years ago.

8030C Input Sensitivity with DJ Mixer

Youngling Posts: 1 Join Date: 4/24/21 Recent Posts

Hello,

A few days ago I bought pair of 8030Cs which are connected via XLR (Master output) to Native Instruments Kontrol Z2 Dj Mixer. However, I´m a little bit confused about how the Input Sensitivity on monitors should be set up. Below are the specifications of Master Output on the mixer.

Master XLR and booth outputs:

Maximum output level+18dBu

Noise floor-89.3dBu / -92dBu(A)

Dynamic range111.1dB / 113.8dB(A)

THD+N<0.0007% (-103dB) @ 997Hz, -1dBFS

Frequency response20Hz - 20kHz +/-1dB

 

Many thanks for suggestions,

Jan