Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

Genelec M040 and wall mounts?..

pavel, modified 5 Years ago.

Genelec M040 and wall mounts?..

Youngling Posts: 5 Join Date: 1/10/17 Recent Posts
Hello,

Could you please help me in the following question?

I want to buy a Genelec M040 and put them on the wall by this wall mounts https://www.thomann.de/pl/millenium_multi_monitormount_mm1.htm As you know this model has Laminar Integrated Port on the bottom. Will they play correctly in this case? I'm asking because in this case front and back sides of monitors will be partially blocked by wall mounts.
pavel, modified 5 Years ago.

Re: Genelec M040 and wall mounts?..

Youngling Posts: 5 Join Date: 1/10/17 Recent Posts
Anyone?..
manutal, modified 5 Years ago.

Re: Genelec M040 and wall mounts?..

Jedi Knight Posts: 180 Join Date: 4/25/14 Recent Posts
I think those would work fine. Maybe some foam pads under them dunno..

https://www.thomann.de/fi/the_takustik_isopad_7.htm
ilkka-rissanen, modified 5 Years ago.

Re: Genelec M040 and wall mounts?..

Yoda Posts: 2564 Join Date: 3/23/09 Recent Posts
I would not recommend using those with the M series monitors as the reflex port will be mostly blocked by the mount. This would cause chuffing noise and change the performance of the monitor.

If the placement angle is not too steep, you could use the mount without the rear support plate which could work better as then only the front side would be partially blocked.
pavel, modified 5 Years ago.

Re: Genelec M040 and wall mounts?..

Youngling Posts: 5 Join Date: 1/10/17 Recent Posts
Thanks fo your answer!