Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

Isopad metal plates

pepsiolli, modified 5 Years ago.

Isopad metal plates

Youngling Posts: 1 Join Date: 9/15/16 Recent Posts

Just a quick question. I have a pair of M040's mounted on some k&m stands(with the 3/8 thread) using isopad metal plates. Should the lip be pointing up or down? Should it be on the front or behind monitor?
ilkka-rissanen, modified 5 Years ago.

Re: Isopad metal plates

Yoda Posts: 2564 Join Date: 3/23/09 Recent Posts
Lip should be pointing up. Front/back depends where you need support i.e. do you want to tilt back of front your monitors.