Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

7040 dip switches and sensitivity

yb8010, modified 6 Years ago.

7040 dip switches and sensitivity

Youngling Posts: 1 Join Date: 7/21/15 Recent Posts
Hello. Could you please write me the function of each of the dip switches on the 7040 sub, from 1 to 7 ? I could not understand it from the manual.
Also, What is the recommended sensitivity level with the 8010 monitors?
thanks
ilkka-rissanen, modified 5 Years ago.

Re: 7040 dip switches and sensitivity

Yoda Posts: 2564 Join Date: 3/23/09 Recent Posts
Hi there,

I am not sure if I am able to explain them any better, the operating manual gives already quite detailed explanation. What is it that you can't understand about them?

Manual also mentions the recommended starting sensitivity level which is -4 dBu.