Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

Input level +4dBU or -10dBV for Genelec M030?

orcoaffamato, modified 7 Years ago.

Input level +4dBU or -10dBV for Genelec M030?

Youngling Posts: 13 Join Date: 11/21/14 Recent Posts
Hi,

I have a RME Fireface 802 audio interface and with Totalmix FX I can select the output level at +4dBU or -10dBV.
Which is the best input level for the Genelec M030?
ilkka-rissanen, modified 7 Years ago.

Re: Input level +4dBU or -10dBV for Genelec M030?

Yoda Posts: 2564 Join Date: 3/23/09 Recent Posts
Hi,

Both levels are acceptable, but I would advice to use +4 dBu and set the input gain setting on the back of the speakers so that you will get enough maximum output before you run out of gain in your source.