Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

8030 has a tighter tolerance?

ado269, modified 7 Years ago.

8030 has a tighter tolerance?

Youngling Posts: 1 Join Date: 10/6/14 Recent Posts
Hello, can explain in detail what is“ it is just a difference in production tolerance.”
Is 8030 manufactured to standards higher than that of the G3?
I know their voices are the same。I'm going to buy 8030 or G3,See the previous question,Doubt is 8030 for better quality.
Thank you so much.
ilkka-rissanen, modified 7 Years ago.

Re: 8030 has a tighter tolerance?

Yoda Posts: 2564 Join Date: 3/23/09 Recent Posts
Hi,

It means the +/- tolerance of the frequency response accuracy/flatness. If you look at our production range, you can see that we have different frequency response accuracy tolerances for different product ranges/product models, typically between +/-1 dB to +/- 3 dB.