Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

7060A placement in the control room

studiowax, modified 5 Years ago.

7060A placement in the control room

Youngling Posts: 2 Join Date: 7/26/12 Recent Posts
Hello, i ask advice for placing my 7060a in the control room shown below.
The 1030's are 80 cm. far from the wall.
The console is pretty deep (146 cm.).

Thanks!

ilkka-rissanen, modified 9 Years ago.

Re: 7060A placement in the control room

Yoda Posts: 2564 Join Date: 3/23/09 Recent Posts
Hi,

Just by looking at the picture, the front wall looks to be the best possible location for the sub. Whether the current left corner location or somewhere around the center or right corner provides best sound quality would have to be tested. Do you have access to gear which could be used to measured the frequency response of the system at various subwoofer locations?
studiowax, modified 9 Years ago.

Re: 7060A placement in the control room

Youngling Posts: 2 Join Date: 7/26/12 Recent Posts
Hi,
thanks for your reply.
At the moment I don't have that gear, I think I'll try to start placing it at the center of the front wall.