Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

1029a calibration

ambrose, modified 12 Years ago.

1029a calibration

Youngling Posts: 1 Join Date: 5/27/10 Recent Posts
Folks,

My first post here so go easy.

I need to use a pair of 1029a loudspeakers in a portable mix setup.

In your experience, were the most 'translateable' mixes achieved using the 'flat' setting, or the -2dB setting on the trebble.

Was the 1029a a 'bright' speaker which needs the -2db off the top?

I'm not too worried about the bottom end problems, as i won't be using a sub. If it makes any difference, i'll be in fairly small rooms, un-treated, perhaps with a back wall close by, and a monitor distance of not-very-far (1m max).

Thank you for your advice and any recommendations --

Ambrose