Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

Mono with GLM?

tesla, modified 12 Years ago.

Mono with GLM?

Youngling Posts: 16 Join Date: 11/18/09 Recent Posts
Hello,


Is there a way to check mixes in mono with the glm software?

cheers
christophe-anet, modified 12 Years ago.

Re: Mono with GLM?

Jedi Knight Posts: 188 Join Date: 3/23/09 Recent Posts
Hello,

Thanks for your post and the good question. Indeed one needs to explain how to have mono reproduction with the GLM software.

First, this function is only possible using digital audio inputs, not analog inputs. You need to use the 'Manual cabling wizard' function in GLM and select both loudspeakers to use and reproduce A+B digital audio channels.

Then you need to save that new 'mono' setup and load it again whenever mono reproduction is needed (via GLM AutoLink you can load setups very quickly using shortkeys). So two setup files are needed, one for stereo reproduction and another one for mono reproduction.

Hope it is clear and helpful.

Best regards,