Genelec Community Forum has been archived

Thank you for all the years of Community discussions and activity!

The time has come for us to retire the community forums, but we will keep everything available for reading. There is a lot of valuable content written over the years, and you'll be able to access all of that. However, no new posts can be written, or old posts modified.

If you have questions, we recommend you use the Support function on the bottom right corner to contact our Customer Support directly.

Alternatively, if you wish to engage in a community discussion with other people, there are many active forums available. There is also an active, fan managed GENELEC COMMUNITY in Facebook, and many Genelec employees are active in the discussions there.

We are sorry for any possible inconvenience this may cause you, but we hope to hear from you through the other channels mentioned above.

Genelec Support

Message Boards

Repair 7050A

cutdivision, modified 14 Years ago.

Repair 7050A

Youngling Posts: 2 Join Date: 5/4/09 Recent Posts
Hello colleagues.
The hubcap of magnetic defence was torn away in my 7050А.
Did I easily return him into place, however as it doing right?
There are the special marks on a hubcap (on a photo). What
position must they be in?
Thank you for a help, Evgeniy Kouzin, Moscow.

P.S. Service is not accessible. I am sorry for English

christophe-anet, modified 14 Years ago.

Re: Repair 7050A

Jedi Knight Posts: 188 Join Date: 3/23/09 Recent Posts
Dear Evgeniy Kouzin,

Thanks for your post and question. The cup mounted on the rear of the bass driver of the 7050A does not require any special mounting orientation. The markings appearing on the cup are probably just from the original mounting orientation of that cup but in no way a special reference position of some sort.

So, the cup just needs to be carefully re-installed with the help of the mounting spring pushing the cup from the back. That's all.

Best regards,
cutdivision, modified 14 Years ago.

Re: Repair 7050A

Youngling Posts: 2 Join Date: 5/4/09 Recent Posts
Dear Christophe Anet.
Thank you very much for support and your answer.
I suspected about it, but now will be more quiet.

With kind regards, Evgeniy producer of editing.

P.S My reference monitoring only with Genelec!